Joints for robots that work beside peopleOrder

From load case to volume

Four steps, one building. The people who size your joint are the people who build it, test it and answer the phone when it comes back.

  1. 01

    Specify

    You send the motion profile, or we record it with you on the machine. Peak and continuous torque, speed, duty cycle, the shocks it takes when a foot lands.

    We come back with a joint size, a ratio, a thermal budget and a price at three volumes.

    • Load case review
    • Joint sizing report
    • Volume pricing
  2. 02

    Prototype

    The flexspline, circular spline and wave generator are cut and ground on our own machines. The stator is wound on our line. Firmware is ours.

    First articles ship in a crate with their own test data, usually eleven weeks after the load case is signed.

    • First articles
    • Per-unit test data
    • Integration support
  3. 03

    Qualify

    Each design runs to failure on the dyno: thermal soak, shock, reversing loads, ten thousand hours on the life rig at elevated temperature.

    You get the raw data. If a joint fails early we tell you why and what we changed.

    • Thermal and shock testing
    • Life rig, 10,000 h
    • Failure analysis
  4. 04

    Produce

    Production runs on the same line that built your prototypes, with the same people. Every joint gets an end-of-line test against the qualified envelope before it is boxed.

    Capacity today is forty thousand joints a year, with floor space to double it.

    • End-of-line test
    • Lot traceability
    • Spares and repair

Have a machine that needs joints?

Start a program